Old cars, DIY and other stuff…
Time to get started covering up the old 914 glas fibre seats. I could not reuse the old upholstry as it was too padded outwards and made the seats to wide to fit into the car. Time to strip everything back and start over. The goal was to make leather seat covers that could easily...
READ MORE
Before the long dark winter I had to roll it out and take a few photos.
READ MORE
A bunch of smaller jobs that doesnt really fit into the other posts. Alternator bracket and tensioner. I’m reusing the stock 850 alternator despite it being quite large and heavy but I had it (no extra cost), I know it works. The tensioner is just two rose joints and a steel tube with a left...
READ MORE
Ok this one is a long one, a process that stretched over a few months with several back and forths and its still not fully finished. So with the bodywork done we can put the engine back in for the last time right? Uhoh, the hood doesnt fit anymore. I already knew about this and...
READ MORE
Time to deal with the instruments. I wanted a minimal setup so Tachometer, Speedo, Oil Pressure, Coolant Temp and Fuel level was all that was needed. First layout was done in Solidworks. Testing the shape in the car. The tacho and speedo was custom ordered from ETB Instruments in the UK. The smaller gauges are...
READ MORE
I knew that the engine ran and worked when we took it out of the donor Volvo. Getting it started again was always a bit of a worry at the back of my mind. Alot of time was spent researching which components and wires went where and what needed to stay and what could be...
READ MOREThe tail lights use the same size ring as the fuel filler cap, so making those was just a repeat of that process. Once the rings are done its time to find the right place on the body. There are a few rules that must be adhered to here regarding the height, angle and horisontal...
READ MORE
So this starts with the same sketch as the fuel filler post. A quick layout of how things should be. The first thing I made was the storage space itself along with the two cover plates for the wheel wells to keep as much dirt and water out as possible. Two helmets and rain gear...
READ MORE
Here is a short rundown of the work with the fuel filler cap and associated bodywork. This is the first basic sketch layout of the rear trunk and fuel filler. The goal is to have a storage space large enough for two helmets and some rain gear in the back above the fuel tank. Making...
READ MORE